Changes of the Channel Source can beĪux Return Channels 1-8 are pre-configured to use the 6 aux input signals,Īnd the two USB playback outputs, but can be patched to use any other availableįX Return Channels 1L-4R control the 4 stereo output signals of side-chain FX1-4.We are in a auditorium with a X32 running FOH and I was wondering how do I set up an output for a camera to hear the main mix? Even though the X32/M32 firmware has been updated frequently over the years with new improvements and features, it does not seem to be able to keep up with the numerous feature toolbox is an attempt to supplement the current features.
Input Channels 1-32 are pre-configured to use the first 32 input signals,īut can be patched to use any other available signal on the audio engine as well, Switches the Main Display to a page displaying all related parameters for Selected channel, and they each have their own View button that, when pressed, The channel strip consists of the following sub-sections:Įach of these subsections correspond to the processing steps of the currently The LED collar and the gain knob are turned off, because there is no input gain to For example, if an output bus is currently selected, Turned off, it indicates that this specific control/parameter is not available for LED collar that indicates the parameter’s value. Within the channel strip, the rotary control knobs are surrounded by an amber The button illuminates to show the effect is active, Strip, simply press the Select button on the desired input or output channel.Ĭertain sections of the channel strip (such as the low cut filter, noise gate, EQ andĬompressor) contain a respectively labeled button that can be pressed to switch Parameters of the currently selected channel.
The X32’s channel strip offers dedicated controls for the most important processing The 16 Mix Bus Masters, which is useful when you wish to include Bus Masters The button will illuminate, reminding you which layer is active.Ī fourth layer (Bus Masters) is also offered, allowing you to adjust the levels of Press any of the correspondingly labeled layer buttons on the left side of theĬonsole to switch the input channel bank to any of the three layers listed above. Separate layers of inputs for the console, including:Īuxiliary Inputs 1-6/USB playback/FX Returns 1L-4R The Input Channels section of the console is located on the left hand side, and DCA Groups (digitally controlledĪmplifier) cannot be selected because they control a number of assignedĬhannels rather than one specific channel. There is exactly one channel selected (either Input Ch 1-32, Aux 1-8, FX ReturnsġL-4R, Mix Bus 1-16, Main LR/C, or Matrix 1-6). (channel strip and main display), to that channel. You will find a select button on top of every channel that is used to direct theĬontrol focus of the user interface, including all channel related parameters
X32 DIGITAL MIXER Preliminary User Manual 4 X32 PRODUCER DIGITAL MIXER User Manual Introduction Welcome to the X32 PRODUCER User Manual! After years of intense development, we are proud to offer a mixer that combines tremendous power and flexibility with a very user-friendly layout and intuitive workflow that allow you to get up-and-running right away.